Commercial Vessel Compliance

‘Findings of Concern’ focuses on the hazards of corrosion

The Coast Guard recently published Findings of Concern 009-19, “Corrosion Caused Casualties,” in order to bring awareness to unsafe conditions discovered last year on a Louisiana towing vessel during a marine casualty investigation.

The Incident.

An Inspected Towing Vessel (ITV) pushing a loaded tank barge experienced a loss of steering and subsequently ran aground, Sept. 25, 2018. The marine casualty investigation determined the initiating event to be the port shaft propeller nut wedged into the rudder, which prevented the free and full movement of the steering gear. (Figure 1)

Photo of propeller nut wedged into the rudder and photo of deteriorated propeller nut locking strap.

Contributing Factors and Analysis.

The investigation identified the initiating event causal factors to be a material failure of the port shaft propeller nuts locking strap (missing), the lack of a secondary securing mechanism (second nut/cotter pin) on the port propeller nut, and an inadequate corrosion mitigation preventative maintenance program. Visual analysis of the starboard shaft locking strap noted significant deterioration of the locking mechanism (Figure 2), requiring immediate replacement. Based on the analysis of this casualty, marine inspectors inspected the locking nut straps of several other ITV’s during scheduled dry-dock exams, which showed similar corrosion issues.

The Coast Guard recommends the following preventative measures:

  • Review company corrosion prevention systems/programs. If necessary, engage with a corrosion specialist from the American Boat and Yacht Council and/or National Association of Corrosion Engineers.
  • Ensure adequate primary and secondary propeller shaft securing devices (cotter pins, double nut, locking strap, etc.) are in place at all times, with consideration given to vessel operations and environmental conditions.
  • Inspect propeller fasteners routinely/during every dry-docking and replace in accordance with manufacturer’s instructions.

The Coast Guard issues findings of concern to disseminate information related to unsafe conditions identified as causal factors in a marine casualty and that may cause a similar casualty on other vessels. Findings of concern are intended to educate the public, state, or local agencies about the conditions discovered so they may address the findings with an appropriate voluntary action or highlight existing applicable company policies or state/local regulations.

These findings of concern are provided for informational purpose only and do not relieve any domestic or international safety, operational, or material requirements. For any questions or comments please contact Marine Safety Unit Lake Charles Investigations Division by phone at (337) 491-7811 or by email at

This blog is not a replacement or substitute for the formal posting of regulations and updates or existing processes for receiving formal feedback of the same. Links provided on this blog will direct the reader to official source documents, such as the Federal Register, Homeport and the Code of Federal Regulations. These documents remain the official source for regulatory information published by the Coast Guard.

1 reply »

  1. Fairwater cap- it’s grease filled and covers the nut and strap to prevent this condition. Has been in use for generations. The other thing that works is occasionally doing maintenance to your equipment before it’s run ragged and rotten. No need for ABYC/ NACE corrosion expert fees to tell you the obvious. Save your money, apply common sense.

Leave a Reply